Abvufer With Built-In Force
One interesting among the low-cost saboophers novels from a known TEAC company in the Truba Corps with a 10-inch probe. It'll be good as the first sab for your car.
Buying expensive models with a split-asser is not always acceptable. Maybe you don't like it or you stop using it. A lot of wires and lines, the difficulty of mounting.
Low and powerful sabovere with the force♪ In fact, there is no equal price and power. According to the specialists, this design is air pumping.
A fairly wide range of reproduced frequencies and adjustments. It's not a high price.
It has a relatively small capacity, not only in any luggage compartment, but may even be separated from the rear seats (depending on the structure of the vehicle).
The uncomplicated connection and the set of all wires make it much easier for a separate installation.
The built-in force of a rated power of 120 Wt to a maximum of 1,600 W will fully satisfy the melomans.
TEAC TE-SA10, 3,600 roubles.
The sabfuver magnet weighs 848 grams! And the dimensions of the whole device 48 x28x30 cm with a weight of 7, 2 kg.
Sensitivity: 89 dB (W/m).
Reproduced frequency range 49 - 1,200 Hz.
Resistance 4 Om.
Catering: 12 Volt (10, 5-16 Volt).
There is a level adjuster (used in primary construction) and a low frequency filter regulator between 40 and 250 Hz.
A standard RCA cable is used to connect to the multimedia system of a vehicle or even a simple magnetoly. There's a remote switch cable.
