Sabovere Booster Pattern
In this material, we will consider the principled design and improvised design of the hull of a quality automobile force with a sabvuffer channel. I had an idea. collect the force For a car and the first thing that started to collect is a voltage converter 12 to 40 volts. The printed fee decided to make a full textolite leaf. He used LUT technology. The printing fee has been made to its size. SIM collected a separate fee. The scheme added only an additional drip to feed AC 24 volts.
The Diode Bridge made on the 4th diode HER-307, further filtered from the condenser 1,000 um, 50 volts. Only part of it was cut off from this scheme. I mean, a stabilizer at 15 volts. The rest stays like a scheme.
For the transformer, the ferrit rings, Russians, 40-CNs were glued together. The sharp edges of the ferrita rounded the diamond thumb. Then he washed with painted scotch. The primary molten transformer washed with 0.8 wire.
Ten of them together lived, five turns were evenly distributed throughout the ring. Next, split up half. The kid's getting analogic. The same wire 0.8 and 8 lived together. Number of turns 15 and then split in half. The outlet voltage was +/-40 volts, under pressure, the voltage was divided into two volts in both shoulders.
Now we've started collecting a sound power. The choice fell on the Laykov 6th version. There was nothing in the scheme. But it's a little difficult. There's a need for a symmetry of both shoulders. I mean, tranchors of the capacitors. It's 150 m.
NFIDA
- 1. R6 and R24 shall be placed in the mean position.
- 2. Put the forcer in the ground.
- 3. Spare the weekend tranchors.
- 4. Schematic power.
- 5. Install R 6 at the outlet of the forcer 0 into the voltage.
- 6. Measure the power supply and +/ ♪
